Macrosystem Quick-Photo Manual do Utilizador descarregar pdf (Página 7)

As mentioned earlier to use Quick Photo on launch you should “Read images” with (1) to

import all photos and / or stills from the Scene Bin that you want to edit with.

If you want to pre-determine the new scene / photo’s run “time” use Stand time (13) so that

each individual image appears later with this length when rendered. This can be adjusted

(individually or en- mass) later if required.

If you clicked “no” earlier you can use “Read image” and in the window displayed you will

see the entire scene bin – Picture 4.

! Picture 04

Here you can see the high-resolution photos marked with little white crosses seen in

Picture 04 (Scene DSCN3843 ) or IMG_1667 enlarged (one red arrow) - Picture 5.

Scenes that have no cross are the first frame from a video clip as in Scene 00021.1 in

Picture 4. You can see if it has already been “trimmed” by the little white triangles to the

left/right (trim from beginning or trimmed from the end) shown in the enlarged section (two

red arrows) - Picture 5.

You can play individual scenes or still images as necessary and select Ok to add to Quick

Photo. To add “more at a time” you can select the scenes you want (Dashed box) and click

on “mark”. In this way, you can select a number of images that then all have a white

square at the top and add them to the Quick Photo project area with the ok button.

! Picture 5

 | Page7

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sem comentários

Macrosystem Quick-Photo Manual do Utilizador Página 7